Health & Fitness

How the Sleep Cycle Calculator Works

How optimal bedtimes and wake-up times are calculated using 90-minute sleep cycles, with sleep onset latency and NHS-aligned duration recommendations.

Verified against NHS — Sleep and tiredness on 15 Feb 2026 Updated 15 February 2026 4 min read
Open calculator
Translated article · View in English

সারাংশ

Sleep occurs in repeating cycles of approximately 90 minutes, each progressing through light sleep (N1, N2), deep sleep (N3), and REM sleep. Waking at the end of a complete cycle — rather than mid-cycle — is associated with feeling more alert and refreshed. This calculator suggests optimal bedtimes or wake-up times aligned to complete 90-minute cycles, adjusted for the time it takes you to fall asleep.

এটি কীভাবে কাজ করে

The calculator operates in two modes:

  1. “When to sleep” mode — given a desired wake-up time, it calculates bedtimes that allow you to complete 4, 5, or 6 full sleep cycles before your alarm
  2. “When to wake” mode — given a planned bedtime, it calculates wake-up times aligned to the end of complete sleep cycles

Both modes account for sleep onset latency — the time between getting into bed and actually falling asleep. The average healthy adult takes 10–20 minutes to fall asleep (Ohayon et al., 2004). The calculator defaults to 15 minutes.

সূত্র

Bedtime = wake_time − (cycles × 90) − latency

Where

wake_time= Desired wake-up time (minutes since midnight)
cycles= Number of complete sleep cycles (4, 5, or 6)
90= Duration of one sleep cycle in minutes
latency= Sleep onset latency — time to fall asleep (minutes)

For wake-up mode, the formula is reversed:

Wake time = bedtime + latency + (cycles × 90)

Where

bedtime= Planned bedtime (minutes since midnight)
latency= Sleep onset latency (minutes)
cycles= Number of complete sleep cycles (4, 5, or 6)

Sleep cycle ratings

CyclesSleep durationRatingRationale
69h 0mRecommendedTop of NHS 7–9h range
57h 30mRecommendedCentre of NHS 7–9h range
46h 0mAcceptableBelow NHS recommendation; AASM considers <7h suboptimal

সমাধান করা উদাহরণ

Wake at 7:00 AM, 15 minutes to fall asleep

1

Convert wake time to minutes

7 × 60 + 0 = 420 minutes

= 420 min

2

5 cycles of sleep (recommended)

5 × 90 = 450 minutes

= 450 min

3

Subtract sleep duration and latency from wake time

420 − 450 − 15 = −45 minutes

= −45 min

4

Normalise to clock time (−45 + 1440)

1395 minutes = 23 hours 15 minutes

= 11:15 PM

Result

Go to bed at 11:15 PM for 7h 30m of sleep (5 complete cycles)

ইনপুট ব্যাখ্যা

  • Mode — choose between “When to sleep” (you set the wake-up time) and “When to wake” (you set the bedtime)
  • Hour and minute — the target time (wake-up time in bedtime mode, or bedtime in wake-up mode)
  • Time to fall asleep — your estimated sleep onset latency (0–45 minutes, default 15)

আউটপুট ব্যাখ্যা

  • Best suggestion — the time for 5 complete cycles (7h 30m), highlighted as the hero metric
  • All suggestions — times for 4, 5, and 6 complete cycles, colour-coded green (recommended: 5–6 cycles) or amber (acceptable: 4 cycles)
  • Sleep duration — total sleep time for each suggestion (not including latency)

অনুমান এবং সীমাবদ্ধতা

  • 90 minutes is an approximation. Real sleep cycles vary from 70–120 minutes, with the first cycle typically shorter and later cycles longer (StatPearls, NCBI). The 90-minute figure is the industry-standard average used by all major sleep calculators.
  • Sleep onset latency varies. The same person may take 5 minutes one night and 30 minutes the next. The calculator uses your estimate, not a measured value.
  • Night-time awakenings are normal and not accounted for. Most adults briefly wake 2–3 times per night without remembering.
  • Sleep architecture changes with age. Older adults tend to have less deep sleep and more fragmented sleep.
  • This is a planning tool, not a medical device. If you regularly take over 30 minutes to fall asleep, or consistently feel unrefreshed despite adequate sleep time, consult a healthcare provider.

যাচাই

Test caseInputExpected outputSource
Standard bedtimeWake 7:00 AM, 15 min latency, 5 cyclesBed at 11:15 PMFormula: 420 − 450 − 15 = −45 → 23:15
Standard wake-upBed 10:30 PM, 15 min latency, 5 cyclesWake at 6:15 AMFormula: 1350 + 15 + 450 = 1815 → 6:15
Zero latencyWake 6:00 AM, 0 min latency, 5 cyclesBed at 10:30 PMFormula: 360 − 450 − 0 = −90 → 22:30
Maximum cyclesWake 7:00 AM, 15 min latency, 6 cyclesBed at 9:45 PMFormula: 420 − 540 − 15 = −135 → 21:45
Minimum cyclesBed 10:30 PM, 15 min latency, 4 cyclesWake at 4:45 AMFormula: 1350 + 15 + 360 = 1725 → 4:45

Sources

sleep sleep-cycle circadian bedtime wake-up nhs